Advanced Fuel Dynamics Plug and Play Active E85 Flex Fuel System for 2009-13 Corvette

Installation Guide for Your Advanced Fuel Dynamics Flex Fuel System

Follow these steps to successfully install your Advanced Fuel Dynamics E85 Flex Fuel System. Prior preparation and careful execution are key to ensuring a smooth and effective installation process.

Pre-Installation Preparation

Before starting the installation, gather the necessary tools and take safety precautions. You’ll need basic hand tools, including a screwdriver set, pliers, and possibly a wrench set, depending on your Corvette model. Always disconnect the negative terminal of your car battery to prevent electrical shorts during installation. Ensure the vehicle is parked on a level surface and the engine is cool. Carefully review the instructions before beginning the installation.

1. Gather all required tools, including screwdrivers, pliers, and wrenches.
2. Disconnect the negative terminal of the car battery.
3. Ensure the vehicle is on a level surface and the engine is cool.

Step-by-Step Installation Process

Follow these steps to install the Advanced Fuel Dynamics E85 Flex Fuel System. (Note: Specific instructions may vary; always consult the detailed manual provided with your system). Begin by locating the fuel lines and sensors. Disconnect the factory fuel lines and sensors. Install the Advanced Fuel Dynamics sensors and fuel lines in their place, ensuring all connections are secure. Connect the wiring harness, ensuring all connections are firm and properly seated. Double-check all connections before proceeding. Reference the provided installation diagrams for visual guidance. If you encounter any difficulties, consult the included troubleshooting section or contact customer support.

1. Locate and disconnect the factory fuel lines and sensors.
2. Install the Advanced Fuel Dynamics sensors and fuel lines.
3. Connect the wiring harness.
4. Double-check all connections.

Post-Installation Tuning and Adjustment

After the installation is complete, the system may require tuning and adjustments to ensure optimal performance. The first step is to verify the system’s functionality by turning on the ignition. The system will start to read and adapt to the fuel blend. Perform the initial setup and calibration steps as outlined in the manual. Some systems may require adjustments based on the fuel blend being used. Fine-tune the system’s settings to optimize performance and fuel efficiency. The exact tuning process will vary depending on the system model, so refer to the manufacturer’s instructions for specific guidance.

• Perform the initial setup and calibration.
• Fine-tune the system’s settings to optimize performance.